Thermal Abuse Test Chamber

Thermal abuse test chamber is suitable for standard IEC 62133-2017, UL 1642 and GB 31241-2014.

Main technical parameters

Model	BE-8103
Structure	All-in-one structure, the door uses explosion-proof lock + explosion-proof chain
	Normal temperature to 150°C (Adjustable)
Temperature Range
Controlling Accuracy	±0.5℃
Temperature Deviation	±2.0℃, No load
Heating Rate	RT～150°C (Linear 5°C/min)
Control Display	PLC touch type (7 inch) + remote control
Working Cabinet Dimension	W600XD500XH600 mm
External Dimension	W940XD780XH1620 mm
Inner Chamber Material	SUS304 Stainless steel with mirror-finish
External Chamber Material	SECC steel plate, fine powder paint coating (thickness 1.5mm)
Bottom	With universal wheel
Observation Window	390 X 360mm (20mm thick explosion-proof glass, explosion-proof mesh)
Insulation Material	Imported high-density glass wool, good heat insulation, to ensure maximum temperature insulation, tight sealing materials for high temperature resistant silicone, withstanding high temperatures over 300 degrees for a long time
Terminal Hole	Diameter 50mm Terminal hole on the left and right sides
Power Supply	220V / 50HZ / 4.0KW
USB Interface	With USB interface, the test data can be exported
Auxiliary Function	Explosion-proof pressure relief device, smoke exhaust device, explosion-proof lighting device, electronic door lock system, safety stop switch

1.Relevant standard test requirements

Single battery safety test

The heating test is carried out as follows:

The single battery is charged according to the method of 6.1.3
Put the single battery into the temperature chamber.
For lithium-ion batteries, the temperature chamber is increased from room temperature to 130 ° C ± 2 ° C at a rate of 5 ° C / min, and the heating is stopped after maintaining the temperature for 30 minutes.
For nickel metal cyanide batteries, the temperature chamber is raised from room temperature to 85 ° C ± 2 ° C at a rate of 5 ° C / min, and the heating is stopped after maintaining this temperature for 2h.
Observe for 1h.

2.Battery module safety test

The battery module battery shall be charged according to the method in 6.1.4.
For lithium-ion batteries, the temperature chamber is raised from room temperature to 130 ° C ± 2 ° C at a rate of 5 ° C / min, and the heating is stopped after maintaining this temperature for 30 minutes.
For nickel metal cyanide batteries, the temperature chamber is raised to 85 ° C ± 2 ° C at room temperature at a rate of 5 ° C / min, and the heating is stopped after maintaining this temperature for 2h.
Observe for 1h.